Odometer Self-Diagnostics / Diagnostic Mode
To enter diagnostic mode:
- Press and hold the trip odometer trigger switch located on the left handlebar controls, while turning the IGN ON.
- Release the trip odometer trigger switch. "diag" will appear on odometer display.
- Press and release trip odometer trigger switch. ECM will appear on odometer display. It will have either a "Y" or an "N" after it, depending if there are any ECM codes or not.
- Quickly press and release trip odometer trigger switch to cycle through the modules. Modules include the BCM, SPDO, ABS and RAD.
- Once the desired module is displayed, press and hold trip odometer trigger switch.
- If any DTCs are stored in the module, the odometer will display the DTC. Quickly pressing and releasing trip odometer trigger switch will cycle through stored DTCs.
- When all DTCs have been cycled the odometer will display "end".
- To clear all DTCs in that module press and hold trip odometer trigger switch, while a DTC is displayed. If DTCs are not to be cleared, quickly press and release trip odometer trigger switch. The part number of the module will be displayed.
- Press and release trip odometer trigger switch again to continue to next module.
- Make note of all DTCs. Clear all DTCs and operate vehicle to verify DTCs set and are current. Historic DTCs are not to be diagnosed unless the condition is reoccurring and intermittent.
- Turn IGN OFF to exit diagnostic mode. If IGN is not turned off, vehicle will exit diagnostics mode when vehicle starts moving.
View the Diagnostic Trouble Codes (DTCs) and Fault Conditions PDF table here!
👆